ENGLISH
67
PARAMETERS VALUES DESCRIPTION
Enable
Yes/No
Enables or disables the function.
Speed
20%-
100%
Sets the pump rotation speed during the
intervention of Antifreeze.
Temperature
4°C - 10
°C
(40°F -
50°F)
Sets the Antifreeze intervention temperature.
The temperature sensor is fitted close to the motor and does not directly
feel the water temperature, but that of the pump motor group. If the pump
is in a technical room, the outdoor temperature may be lower, even much
lower, than the one measured by the sensor.
ANTI-LOCK
This function prevents mechanical blocks occurring in the case of long inactivity; it acts by periodically turning the
pump, at a very low speed that does not create a head.
PARAMETERS VALUES DESCRIPTION
Enable
Yes/No
Enables or disables the Anti-Lock function.
When the function is enabled, the pump
performs an unlocking cycle lasting a few
seconds every 23 hours (elapsed without any
start of the pump).
ATTENTION: The protections work only as long as the system is regularly powered: with the electric power
disconnected or in the absence of current (even accidental, such as after a blackout) the protection cannot work. So it
is advisable not to leave the system loaded during periods of inactivity in winter, but empty it accurately.
In cases of long inactivity, it is advised not to disconnect the electric power to keep the antilock protection active (see
the following paragraph).
The intervention of protection function turns the pump even if the system is in STOP status (white led blinking), and
is not influenced by the active operating mode (manual or automatic).
If you want to prevent protection function intervening and turning on the motor, the function must be
disabled.
5.7 ALARMS AND FAULTS LOG Menu
FAULTS LOG
This item on the menu allows you to consult the fault history and erase it.
Sub-Menu
DESCRIPTION
Display fault
chronology
The alarms list is scrolled with the up arrow and
down arrow keys.
Once the maximum number of faults that can
be stored (up to 16) has been reached, the
oldest faults are overwritten.
Delete fault list
Pressing the "ENTER" key deletes the list
