2
3. OVERALL DIMENSION
Model
A
B
C
D
E
F
G
H
N.W
(KG)
G.W
(KG)
Vario1.1
325
603
328
222
272
332
268
188
16.9
19.5
Vario1.5
325
603
328
222
272
332
268
188
17.9
21
Vario2.2
325
603
328
222
272
332
268
188
20.8
23
4. INSTALLATION
4.1. Pump Location
1). Locate pump as close to pool as practical and run suction lines as direct as possible to
reduce friction loss.
2). To avoid direct sunshine or heat, It is recommended to place pump indoor or in the shade.
3). Do NOT install pump in a damp or non-ventilated location. Keep motor clean. Pump motors
require free circulation of air for cooling.
4.2. Piping
1). For improved pool plumbing, it is recommended to use a larger pipe size. When installing
the inlet and outlet fittings (male adaptors), use thread sealant.
2). Piping on the suction side of the pump should be the same or larger than the return line
diameter.
3). Plumbing on the suction side of the pump should be as short as possible.
4). For most installations we recommends installing a valve on both the pump suction and
return lines so that the pump can be isolated during routine maintenance. However, we also
