Aqua Leader Contempra Round, General Instructions Manual

Insert each end of the stabilizers into the other along the length of the wall.  
Make sure every stabilizers fits on the pool wall. (image 26)

Align the top plate on the upright and insert it in. The top plate slides into 
the top of the upright by applying pressure thus securing the wall and the 
upright together. Secure it with four screws: two on the sides and two on top. 
(image 27). Apply pressure on the rear part of the top plate while you insert 
the side screws.

Position and place the top ledge on the upright. The top ledge must be 
pushed toward the inside part of the pool and the screw holes on the top 
ledge must align with the holes on the top of the upright. (image 28)

Insert partially the four Phillips screws on the top and the six hexagonal 
screws on the front. Distribute evenly the space between the 

Use the optical level to ensure that the ground 

is perfectly flat and level

.

IMPORTANT NOTE:

IMPORTANT NOTE

Ensure to leave a gap between the two 
stabilizers.

11.

 Install the stabilizers and top plates

12.

 Install top ledges

Make sure to level the two axes of the uprights by pushing slightly inwards 
before tightening the screws permanently.

18

26

27

28

4x

Use the optical level to ensure that the ground 

is perfectly flat and level

.

IMPORTANT NOTE:

IMPORTANT NOTE

If you have some LED lights, you should 

install them now. Refer to the LED instruction 

manual to install them properly

06

SECTION

GENERAL INSTRUCTIONS  -  ROUND POOLS

ASSEMBLING

THE POOL FRAME

10.

 Install the uprights

9.

  Install upright bracket

4x

4x