7
02
SECTION
GENERAL INSTRUCTIONS - ROUND POOLS
3.
Levelling your pool site
The entire pool area must be completely levelled. Level it using carpenter’s
level and a straight plank.
Nail one end of a straight 2-by-4 (5cm x 10cm) wood plank to the top of the
stake. Use a nail long enough to hold the end of the 2-by-4 (5cm x 10cm)
wood plank to the stake while you rotate it in a circle.
Put a carpenter’s level on the wood plank and swing the board in a circle to
level the area. (image 3)
DO NOT ADD GROUND FOR LEVELLING YOUR POOL SITE. You must dig down
to the lowest point of your pool site. Any added ground won’t give the needed
strength to support pool’s weight.
Take material such as rock dust or fine mortar that can conform a solid, per-
manent base ad deposit this material around the rim of the basin. The mate-
rial used should be spread around the perimeter of the pool to a width of 24”
(60cm) and a thickness of 2” (5cm).
Note: Bottom rails will be placed in the center of the perimeter of the pool see
the dashed line.
Lay out the bottom rails and bottom plates around the circle.
3
GROUND
PREPARATION
Summary of Contents for Contempra Round
Page 1: ...GENERAL INSTRUCTIONS for regular installation...
Page 24: ......
