Visit our website to see more of our products.
www.AquaLogicInc.com
Aqua Logic, Inc.
9558 Camino Ruiz.
San Diego, CA. 92126
PH: 858.292.4773
email: info@aqualogicinc.com
www.AquaLogicInc.com
© 2017 Aqua Logic, Inc. Rev 1
DC SERIES SINGLE STAGE DIGITAL TEMPERATURE
CONTROL INSTRUCTION MANUAL
Model No. DC115S, DC115S-20 and DC230S
Thank you for purchasing our digital temperature controller. It is
designed to provide on/off control for commercial heating and cooling
applications. It is equipped with a red LED display that provides a
constant readout of the water temperature, and a touch keypad that
allows the user to easily and accurately select the setpoint
temperature, differential and heating / cooling modes of operation.
The control enclosure has an NEMA 4X rating but, if installed
outdoors, it should be protected against the direct weather.
Installation.
1. Mount control on a wall or any vertical surface that water
can’t splash on it.
2. Plug-in the 115V (230V) control female plug from into the
male plug of the chiller or heater.
3. Plug-in the 115V (230V) control male plug into wall outlet.
4. Install the titanium temperature sensor in your tank or sump.
Note:
For your safety, you must plug the control into a dedicated 15 or 20
Amp. GFIC (Ground Fault Interruption Circuit) circuit. When installing the
control in a wet area make sure to have the power cords with drip loops so
water does not collect around the electrical connections.
Inline Titanium heaters
1 kW thru 60 kW
Safety water flow
cutout switches
1” thru 3” pipe
TLC Trimline Cyclone Drop-
in coil water chillers -1/4
and 1/3 HP
Delta-Star inline water
chillers. -1/4 thru 1-1/2 HP
