7
1.
Delivery
The reverse osmosis system platinum line plus is supplied with three large 10" filter housings. The
filter cartridges (activated carbon, fine filter and demineralization resin) can easily be replaced. The
fitted pressure gauge will display the operation pressure at any time. All components, the prefilter
housings and the membrane module are mounted onto a stable powder-coated bracket. The unit
has a high pressure pump and a flushing valve and therefore, can achieve a high ratio of pure to
waste water output up to 1:1. The salt removal rate is up to 99%. Due to the fully automatic back
flushing and continuous monitoring of the pure water, the unit requires very little maintenance.
It consists of the following parts:
- Fine filter 10" with
5 µm pore size
- Combined filter (fine and activated carbon filter)
- Reverse osmosis module 400 litres/day with a first class synthetic membrane
(Polyamide/Polysulfon, TFC) with a daily output of up to 400 litres (5)
- Flush valve:
at this valve, the permeat/concentrate ratio is adjusted to 1:2 (to maximum
1.1).
- Demineralization filter
- 24 V DC high pressure pump incl. control unit
- Tap water connection fitting
(3/4") incl. pressure tube
2. Set-Up
The reverse osmosis system is mounted on a bracket. This should be fixed on the wall
preferably
near a water connection. Then, connect the tubes. To avoid any failures, follow the instructions
carefully:
Tube fittings:
1. Remove the blue lock ring.
2. Insert the hose to a complete stop into the fitting.
3. Refit the lock ring.
4. Pull the hose back as a test that it is located.
Removing the tubes:
1.
Remove the blue lock ring.
2.
Push the ring back towards the fitting with a finger nail. Now, you
can remove the tube.
3.
Please don’t forget to refit the lock ring.
Fig. 1: Connecting the tube fittings
Summary of Contents for platinum line plus
Page 32: ...32 ...
