7
Programmable light control for LEDspot 100/200 W
(or other units that are controlled by
pulse width modulation)
-
up to 3 LEDspots are controllable at the same time
-
no installation on the PC is required
-
a software update is possible online via USB
-
24 V safety voltage
1.
Technical Data
Line voltage:
230 Volt/50 Hz (if not stated otherwise on the ID-label).
-
safety tension 24 V with external power pack
-
computer control with USB connection for timer and dimming
Dimensions:
14,3 x 5,2 x 4,1 cm (l x w x h)
2.
Unpacking
On unpacking, please check the lighting system immediately for any damages. In case of any
complaints, please contact your dealer directly.
Included in shipment:
•
Timer sunrise control incl. inverted program for LEDspot
•
USB stick incl. programs
•
USB cable
•
Connection cable for LEDspot
3.
Installation
Important: Before inserting or removing the control cables (Fig. 3, No. 8) always
disconnect the power supply (Fig. 3, No. 7) first.
3.1. Program setting
Light control:
-
USB-connection for PC (Fig. 3, No. 6)
-
Software „DimEdit“ is included, no installation on the PC is required.
-
Ten control programs are pre-programmed that can be changed with the included software
„DimEdit“ individually. A software update is possible online.
-
Four separately programmable and dimmable channels for white LED’s, blue LED’s, moonlight
und cloud flying (only the white channel can be used with LEDspot).
-
external power pack 24 V
The lamp is pre-programmed. Changes can be made directly at the clock or by the USB-cable at
the PC. The included USB-stick contains the program for the installation on the computer.
Furthermore, the program is available for download under the following link:
Link for downloading the current software:
http://www.aqua-medic.de/downloads/DimEdit.exe
Link for downloading the ZIP containing the 10 current sample programs (not applicable for
LEDspot) that are already pre-programmed in the clock.
http://www.aqua-medic.de/downloads/DimFiles.zip
These programs are not suitable for dimming the LEDspots. For dimming, the inverted and stored
program on the sunrise control has to be used. Where 100% light is desired, the program has to be
set to 0%, where the light should be dimmed completely down, 100% has to be set.
