AMTRON
®
E-30 Mounting and operating instructions
17
Primary M-Bus address
(factory setting: 0) *
Secondary M-Bus address
(factory setting: serial num-
ber) *
Data transmission mode
(length and format of
M-Bus protocol) *
Firmware version
Checksum
High-resolution
heat quantity *
High-resolution
volume *
Return to main menu
(Press key for 2 seconds) *
*: Display of values can be suppressed
To leave the archive level, either double click
the key when the month is displayed or wait 5
minutes.
19.6.Control level tariff /
cooling (example)
The following settings are shown in this level:
•
Averaging time period and average value
•
Tariff function (surcharge meter)
•
Switchover between heating and cooling
measurements
The meter readings indicated by Tariff 1 are
only updated if the corresponding Tariff 1
conditions are fulfilled. This function is also
termed surcharge meter.
The tariff conditions can be set with the Mini-
Com 3 service software:
•
Time setting (from Time 1 to Time 2)
•
>
or
limit value, power
•
>
or
limit value, flow rate
•
>
or
forward flow or return flow tempera-
ture
•
>
or
temperature difference
Note:
The main energy register sums the total
energy. The Tariff 1 register sums separately
and additionally the energy if the correspond-
ing Tariff 1 conditions are fulfilled (hence the
name surcharge meter).
Set averaging time period
for flow rate and power*
Power in current
averaging time period *
Flow rate in current averag-
ing time period *
Time to start Tariff 1 / sur-
charge meter (when acti-
vated) *
Time to end Tariff 1 / sur-
charge meter (when acti-
vated) *
Switching temperature for
cooling measurement
(when activated) *
Switching temperature for
negative temperature dif-
ference for cooling meas-
urement (when activated) *
Correction for wa-
ter/antifreeze mixture *
(adjustable in factory only)
Return to options menu
(press for 2 seconds) *
*: Display of values can be suppressed
