NOTE:
Your light unit is tested to IPx7.
This means that it can withstand temporary submersion.
However,
IT IS NOT A SUBMERSIBLE LIGHT
EasyGlow 80 / 100 / 120
Set Up and Maintenance
Locating the light unit
Position the lights down the length of the aquarium (left to right). The
are brackets located on the ends of the light unit, these should be
positioned over the top edge trim of the aquarium. Please ensure the
light unit is firmly in place before switching on.
Replacing the flourescent tubes
Switch the light unit off, remove the plug from the mains supplyand
the complete light unit from the aquarium before performing mainte-
nance of any kind. Unscrew the white end caps of the tube holders
by turning them clockwise. Both caps need to be removed before the
tube can slide out. Do not throw away the end caps as they are
required for re-installation of the new tube.
Installing new tubes
With the light unit unplugged from the mains supply and the light unit
removed from the aquarium, slide the endcaps over the tube at
bothe ends. Gently slide the tube pins into the end cap receptacles.
Completely tighten the the end caps back on the receptacle threads.
Be careful not to cross thread as this is a water tight seal. Only
tighten by hand.
(please read the general safety instructions on the other side before installing the light unit)
Your new EasyGlow light unit uses standard T8 size Aquarium Flourescent tubes. They are available as a replace-
ment part from your Aqia One dealer. Light tubes are not covered by the guarantee. Life expectancy is generally 10
months or more, however aquarium flourescent tubes loose their effictive output gradually over time. To maintain
the health of plant and aquatic life effected by the amount of light available, we suggest changing the tubes every 6
months.
Instruction version:- 25/02/2008
