13
If you are in any doubt about the electrical
installation or safety of this product you
must consult a qualified electrician.
LIGHT UNIT DOES NOT WORK
1. Ensure that the light switch is in an on
position.
2. Check light is plugged into power supply
and the switch is on.
POWER HEAD WORKING BUT NO / SLOW
WATER FLOW
1. Check impeller is in good condition and
replace if needed.
2. Make sure water level in aquarium
is above the power head. Please note
the power head is a water proof unit.
3. Clean impeller, power head and all inlet and
outlet pipes.
4. Check that the spray bar is inserted correctly
with the end cap at the opposite end to the
elbow.
AQUARIUM POSSIBLY LEAKING
1. Clean carbon cartridge as this can create
an overflow.
2. Make sure spray bar holes are pointed
down onto the carbon cartridge.
3. Make sure water level is not to high (see
page 7 Step 16).
4. If an air stone is being used check it is not
bubbling water over the rim of the aquarium if
so turn the air pump down.
5. Make sure the aquarium is sitting on a level
surface.
6a. Turn off and unplug all equipment.
Remove filter media. Mark the water level on
the aquarium.
Remove any excess water that may be
sitting on the edge of the aquarium with a
clean towel. Leave for an hour. If water level
drops proceed to step 6b.
6b. Remove the fish, decorations and gravel.
Empty the aquarium and clean the glass
DO
NOT WASH IN SOAP OR DETERGENT.
Place a piece of newspaper on a flat level
solid surface. Carefully fill the aquarium
ensuring not to spill any water on to the
newspaper. Leave the aquarium for several
hours and then inspect the newspaper for
wet patches.
Trouble Shooting
