6
1. Wash your hands and arms. It is very
important to remove dirt, moisturizer and
other impurities. Do this whenever you work
on the aquarium.
2. Rinse the following DO NOT WASH IN
SOAP OR DETERGENT.
Filter Sponge, Carbon Cartridge, Filter Grid,
Spray Bar, Intake Pipe, Intake Strainer, Elbow,
Glass Tank (Inside).
3. Mount the Power Head on the filter. To do
so, fit the Rubber Mount to the Power Head
and slide the mount onto the bracket on the
filter body.
Run the power cable through the gap under
the lid as shown
4. Connect the Intake Pipe and Strainer
together as shown below.
5. Attach the intake pipe to the bottom of the
Power Head as shown above.
6. Place the filter grid in the bottom of the filter
unit as shown in Fig 3 on page 4.
7. Place the black filter sponge on top of the
Filter Grid as shown in Fig 3 on page 4.
8. Place the carbon cartridge on top of the
black filter sponges with the wool facing
upwards as shown in Fig 3 on page 4.
9. Connect the elbow in to the Rubber Mount
at the top of the power head as show below.
Spray Bar
Outlet holes
10. Then connect the spray bar to the other
end of the elbow. Make sure the holes of the
spray bar are pointing down and that the end
of the spray bar has the cap fitted as shown
above.
Set Up Instructions
