4
GB
1. Select the location for your aquarium. Avoid
direct sunlight and areas where temperatures
fluctuate greatly such as in front of heaters and air
conditioners.
2. Place the aquarium on a flat, level surface.
We recommend the use of an Aqua One aquarium
cabinet.
3. Lift the filter lid of the aquarium, this will allow
access to all parts of the aquarium including the
light and filter.
4. The filter comes assembled and no setup is
required. However, check all pipes are connected
securely and the filter media is in the correct
position as per the diagrams on the previous page.
5. Wash aquarium gravel. Place a portion of gravel
in a bucket, run water through and churn the gravel
until the water running out of the bucket is clear.
Repeat this until all the gravel is washed.
6. Place the gravel into the bottom of the
aquarium.
7. Place any rocks, ornaments or plants into the
aquarium.
8. If the aquarium is to be used for tropical fish,
place the heater in the aquarium. Follow the
instructions provided with the heater to set up and
install the heater. (model 30 only)
9. Fill the aquarium with water. The water level
should be below the plastic frame on the inside of
the aquarium but high enough that the water level
is not visible when the aquarium is running.
10. Add water conditioner to the water, follow the
directions on the label.
11. Close the filter lid.
12. Ensure your hands are dry and plug the power
cords into a power outlet. Drip loops as described in
the important safeguards section of this instruction
booklet must be used.
13. Once the unit is turned on at the power outlet
the filter should automatically start
14. To switch on the light unit use the switch located
on top of the filter lid.
15. For (model 11) if desired the rotating switch can
also be switched on.
Setup Instructions
Replacement Parts & Filter Media
Use Aqua One Genuine Spare Parts Only. See
your local Aqua One Dealer and look for the
spare part you require. Alternatively you will
find these numbers on the silver label located
on the product.
Impeller
98
I
Carbon Cartridge
98C
Aqua One Spare Parts
3I
Before First Use/Preparation
Read and follow all the instructions, even if you feel
you are familiar with the product and find a place
to keep the instructions handy for future reference.
Your attention is drawn particularly to the sections
concerning
“IMPORTANT SAFEGUARDS”
and the
“GUARANTEE CONDITIONS”
. Please ensure you
retain your original purchase receipt in the event that
guarantee service is required.
Carefully unpack the aquarium making sure you
keep all the packing material until all the parts of the
product have been found and the product has been
assembled.
This product is shipped to you in a factory sealed
carton. Should the product malfunction in any way
or if the unit is damaged and requires replacement,
contact the retailer where the product was purchased
for inspection.