11
PROBLEM
SOLUTION
SPLASHER
gets stuck in a
particular place
• Adjust the hose length by either adding or removing a hose.
• Ensure that the aimflow nozzle is not interfering with the movement of the
SPLASHER. If so, adjust the aimflow nozzle to direct the flow away from the
unit.
• If the problem persists, attach The Easy-Out Jogger on the first hose and insert
an aimflow diverter ball in the aimflow nozzle.
• NOTE: The Easy-Out Jogger helps to get your SPLASHER out of difficult
corners. It can be fitted between the 2nd and 3rd hose length, small side facing
the weir and the bigger side facing the cleaner. The Easy-out Jogger cone will
float on top of the water
SPLASHER does not
sink
• Ensure there is no air trapped in the hoses or unit.
• Ensure that the SPLASHER has Its weight in the unit.
SPLASHER
does not climb
• Ensure that the baskets and cleaner are free of debris so that there is maximum
water flow and backwash the filter.
• Ensure adequate suction. Adjust the flow control valve settings to a higher
setting. This increases the suction flow through the pool pump.
• Sand or filter cartridge may need to be changed or backwashed.
• Is the Disc curling at the edges? The Disc needs replacing.
• Is the pool radius sufficient for the SPLASHER to climb the walls? The
recommended radius is at least 300mm.
• Check the float chamber for buoyancy, no water should be present in the
chamber
• Is the outer tube or outer extension pipe excessively worn (in excess of 2mm
play)? Replace if necessary.
SPLASHER climbs
out of the water
• Ensure that the flow control valve is working and free of debris.
• Lower the setting on the flow control valve to reduce water flow through the
flow control valve and increase the bypass flow.
TROUBLESHOOTING
