14
TURNING ON THE HEATER MANUALLY- MAINTAINING HEAT
Ensure the spa is in Active Mode.
Press the
button to adjust the temperature to the desired temperature.
Press this
button to turn on the heater manually.
You will see the word heat flashing on the touchpad, once the heat word goes solid and stops flashing the
spa is heating. If you leave the spa in active mode and leave this button turned on permanently it will
maintain the set temperature within 3 degrees. For example, if you set the spa to 38 degrees it will take the
spa to 38 degrees automatically turn off and when the spa drops 2 to 3 degrees in temperature it will turn
back on and re heat the spa to 38 degrees. If the head word in not flashing or solid on the touch pad the
button has been turned off and will need to be re pressed to turn this feature back on.
TURNING ON THE HOT WATER MASSAGE PUMP
Ensure the spa is in Active Mode.
Press this
button to turn on the hot water pump.
To turn off the hot water pump press the same button again.
This pump will automatically turn itself off after a set amount of time running, if it turns off while you are
in the spa you can press the same button to make it run again.
TURNING THE LIGHTS ON & OFF
Ensure the spa is in Active Mode.
Press this
button once to turn on the lights, the lights will now alternate between a number of
colours.
To hold a particular colour press this
button second time.
To turn the lights off press the button a third time
FROST PREVENTION SYSTEM
If the temperature of the spas water drops below 5°C the spa will switch on the heater until the spa
reaches the temperature of 8°C.
OZONATOR
The spas ozonator will automatically turns itself on and off when required, there are no adjustments you are
able to make.
TROUBLESHOOTING
