7
Water chemistry test history showing results for Free Chlorine, Total Chlorine, pH, Alkalinity, Calcium
Hardness & Cyanuric Acid, must be kept as a dated once-a-month digital reference as part of your warranty
terms. This test history will be required in the event of a warranty claim. It is a requirement of the Warranty
Terms to keep dated once-a-month digital water test result of the water chemistry supplied from a professional
pool or spa store. Your warranty will be made void if you cannot show these results.
THE FOLLOWING CHEMICALS CANNOT BE USED IN YOUR SPA:
Bromine, Liquid chlorine, Hydrochloric acid, Trichlor chlorine, Dichlor chlorine, Stabilized chlorine, Cyanuric
acid, Magnesium, Hydrogen peroxide & Polyhexamethylene biguanide.
SOME OF THESE PRODUCT WILL MAKE YOUR FIBREGLASS SPA SHELL DEFORM IN SHAPE &
CREATE BUBBLES & HOLES IN THE SPAS ACRYLIC LAYER.
Your warranty will be made void if you use any of these products.
HOW TO REMOVE YOUR SPAS FILTERS
Remove the flat head screw in the filter box face and dispose of it.
DO NOT REINSTALL THE SCREW.
1.
Slide the face plate on the filter box vertically upwards until it separates away from the filter box.
2.
Remove the leaf catcher by sliding it horizontally towards the centre of the
spa.
3.
To remove the filter, turn the handle on the top of the filter anti-clockwise
until you can lift the filter out of the filter box.
4.
To install the filter, place the filter inside the filter box and turn the handle
on the top of the filter clockwise. Do not turn the filter with force just gently
screw it in so it can be easily removed for weekly cleaning.
5.
To install the leaf tray slide it horizontally into the filter box, make sure the tray sits in the middle of
the locating grooves. The filter face plate will not install if you have the leaf tray outside of the
locating grooves.
6.
To install the face plate on the filter box slide the face plate vertically downwards.
Note:
The black filter face will go white where the water and air meets from chemical exposure.
This is unpreventable and can occur very quickly if you over sanitize the water.
WEEKLY FILTERS CLEANING
Once a week remove the filters from the spa and wash thoroughly with a garden hose, then place the filter
in a bucket of cold water and add 125ml of Filter Cleaner & Degreaser #9 or Filter Cleaner & Degreaser
1Litre Bottle. Agitate the water and leave the filter submerged to soak for 24 hours. After 24hours remove
the filter, wash it thoroughly and allow it to completely dry out in an area exposed to the sun or wind.
It is recommended to purchase a spare filter and alternate between the filter each week to make the
cleaning process easier. Filters which are not cleaned weekly can cause your spa to stop cleaning &
heating.
You filter needs to be replaced every twelve months, however if you are rotating between two filters this will
require replacement every two years. To order your replacement filter
https://www.aquapulsespas.com.au/spa-supplies-parts/universal-cartridge-filter-2/
FILLING YOUR SPA WITH WATER – AVOIDING AIR LOCKS
The correct way to fill your spa with water is to remove the spas filters
and place your hose inside the filter box. Be sure to remove the fitting
off the hose to prevent it from falling into the spas plumbing.
Placing the hose inside the spas main seating area may cause a build-
up of air inside the plumbing creating an air lock. Air locks can stop the
pumps and heater from working.
To help avoid this problem ensure you fill up the spa through the filter box. You can tell if you have an air
lock by turning on the pumps, if no water appears to circulate through the system it is very likely that you
have an air lock. To resolve this problem, turn the pump off and loosen the unions at the side of the suction
