39
Basic Installation and Configuration Guidelines
Use minimum 6AWG copper conductors only.
Torque field connections between 21 and 23 in lbs.
Readily accessible disconnecting means to be provided at time of installation.
Permanently connected power supply.
Connect only to a circuit protected by a Class A Ground Fault Circuit Interrupter (GFCI) or Residual Current
Device (RCD) mounted at least 5’ (1.52M) from the inside walls of the spa/hot tub and in line of sight from
the equipment compartment.
CSA enclosure: Type 2
Refer to Wiring Diagram inside the cover of the control enclosure.
Refer to Installation and Safety Instructions provided by the spa manufacturer.
Warning:
People with infectious diseases should not use a spa or hot tub.
Warning:
To avoid injury, exercise care when entering or exiting the spa or hot tub.
Warning:
Do not use a
spa or hot tub immediately following strenuous exercise.
Warning:
Prolonged immersion in a spa or hot tub may be injurious to your health.
Warning:
Maintain water
chemistry in accordance with the
Manufacturer’s instructions.
Warning:
The equipment and controls shall be located not less than 1.5 meters horizontally from the spa or
hot tub.
Warning! GFCI or RCD Protection.
The Owner should test and reset the GFCI or RCD on a regular basis to verify its function.
Warning! Shock Hazard!
No User Serviceable Parts.
Do not attempt service of this control system. Contact your dealer or service organization for assistance.
Follow all o
wner’s manual power connection instructions. Installation must be performed by a licensed
electrician and all grounding connections must be properly installed.
CSA Compliance/Conformité
Caution:
•
Test the ground fault circuit interrupter before each use of the spa.
•
Read the instruction manual.
•
Adequate drainage must be provided if the equipment is to be installed
in a pit.
•
For use only within an enclosure rated CSA Enclosure 3.
•
Connect only to a circuit protected by a Class A ground fault circuit
interrupter or residual current device.
•
To ensure continued protection against shock hazard, use only identical
replacement parts when servicing.
•
Install a suitably rated suction guard to match the maximum flow rate
marked.
Warning:
•
Water temperature in excess of 38°C may be injurious to your health.
•
Disconnect the electrical power before servicing.
UNLESS YOU HAVE THE APPROPRIATE ELECTRICAL LICENCE DO NOT OPEN THE SPAS
COMPUTER BOX, PLEASE CONTACT THE STORE OF PURCHASE FOR DETAILS OF A LICENCED
QUALIFIED ELECTRICAL CONTRACTOR.
