15
TURNING ON THE HEATER MANUALLY- MAINTAINING HEAT
Ensure the spa is in Active Mode.
Press the
button to adjust the temperature to the desired temperature.
Press this
button to turn on the heater manually.
TURNING ON THE HOT WATER MASSAGE PUMP
Ensure the spa is in Active Mode.
Press this
button to turn on the hot water pump.
To turn off the hot water pump press the same button again.
This pump will automatically turn itself off after a set amount of time running, if it turns off while you are
in the spa you can press the same button to make it run again.
TURNING ON THE AIR BLOWER
Ensure the spa is in Active Mode.
Press this
button to turn on the air blower.
To turn off the air blower press the same button again.
This air blower will automatically turn itself off after a set amount of time running, if it turns off while you
are in the spa you can press the same button to make it run again.
TURNING THE WATERFALL ON & OFF
The waterfall will only run whilst the spa is heating once the desired heat is reached the waterfall will
not run. When using the waterfall handle do not apply pressure to the handle at the fully open or fully
closed positions you will break the handle if you do.
To run your waterfall, turn the manual – maintaining heat button on and set the temperature button at
least two degrees above the current water temperature.
Press the
button to adjust the temperature two degrees higher that the current temperature.
Press this
button to turn on the heater manually.
