P L U G - I N T R A N S F O R M E R – I N S T A L L A T I O N I N S T R U C T I O N S & O W N E R S M A N U A L
INSTALLATION INSTRUCTIONS
1
Find a suitable location for the mounting of the Transformer. It should be mounted undercover and at
least 500mm off the ground.
2
Use the Template provided on this sheet to drill mounting screw holes at 93mm apart. Screws and wall
plugs are provided. Mount the transformer onto the mounting screws. See
Diagram D
.
3
To connect the light cables: first remove 20mm of outer cable sheath and then bare back the two
sheathed conductors to expose 8mm of tinned copper. See
Diagram A
.
4
Locate the Connectors, which are supplied in a plastic bag. Affix each of the cables to the connectors
and tighten screws, see
Diagram B
.
Align and push the connectors into the receptacles on the underside of the transformer, See
Diagram C
.
5
Plug transformer into a 240v power point, turn pool lights on to test
for a maximum of 10 seconds
.
Then leave pool lights off until fully submerged.
2
Automatic Pool Cleaners (Australia) Pty Ltd
40 Percy Street, Auburn NSW 2144
Ph: 02 9643 8338 Fax: 02 9643 8448
www.aquaquip.com.au
COPYRIGHT AUTOMATIC POOL CLEANERS (AUSTRALIA) PTY LTD TAPL5142p_1116
93mm
Mounting Holes Template
TRANSFORMER
12 VOLT
120VA
4
QUAD
OUTLET
20mm
93mm
8mm
Diagram A
Cables
Diagram B
Connectors
Diagram D
Mounting
Tighten screws
Diagram C
Underside of transformer
