Aqua-world Round Satinwood, Assembly

PART 1 - INTRODUCTION

1. READ THE INSTRUCTIONS

Read all instructions completely before you begin.

These instructions explain how to install your pool. Simply follow the step-by-step directions specified in the instructions. Please note 
that Part 6 includes Safety Instructions and Parts 7, 8 and 9 include instructions to help you keep your pool clean and in good shape, year 
after year. Be sure to read the Safety Instructions carefully and make sure everyone who uses your pool reads and understands them.

Note:

 The illustrations shown here may not correspond exactly to your pool, but are designed to aid the installation instructions. The 

manufacturer reserves the right to make changes.

2. PREPARE THE NECESSARY TOOLS AND EQUIPMENT

Before starting pool assembly, please prepare the necessary tools. You will need:

•  A spade, pick, rake, shovel and wheelbarrow for moving soil and sand;

•  A wooden block, about 5 x 10 cm, whose length is longer than one half of the pool, wooden pins, wooden stakes 2.5 x 2.5 cm with a 

flat upper end and approximately 15 cm long, a bag with flour or fine sand, a ball of twine, knife, spirit level, measuring tape, hammer 
and nails for the measurement and preparation of a flat base; 

•  Paving blocks for reinforcing the base under the pool structure (see Part 2);

•  Sieved sand for levelling the base and for creating corner filling (see Part 3 of the instructions);

•  Phillips screwdriver and a flat bladed screwdriver, combined pliers, textile adhesive tape (for carpets) with a width of 50 mm, if 

possible, knife, clothes pegs for the pool assembly.

Note:

 With regard to the wooden stakes, we recommend you to pre-bore a sufficiently large and deep hole (See Part 2, Preparing the 

base). Wooden pins may be replaced e.g. with large nails.

Before assembling the pool, we recommend you assemble the stepladder, as this will come in handy during pool assembly, when it is 
necessary to enter and exit the pool. The instructions for stepladder assembly can be found in the stepladder kit.

3. CHOOSE A SUITABLE DAY FOR POOL ASSEMBLY 

Ideally, choose a sunny day for assembly. Do not attempt to assemble the pool when it is windy. You will require the assistance of at least 
one adult.

4. REPLACEMENT PARTS AND SERVICING

Should you need advice, or if you require pool servicing, or to obtain a replacement part, please contact your dealer. Use original 
replacement parts for maintenance and repairs.

5. WARRANTY TERMS

The Warranty Terms and Conditions are provided for in the Dealer’s Warranty Certificate.

Round Satinwood Pool

2