Aqua reserves the right to apply a service charge if the product returned for warranty
repair is found to be operating correctly.
Recommended procedure to obtain the repair service (during warranty period and
outside)
Contact Aqua, preferably via e-mail at support@aquahifi.com, and briefly describe the
problem. In case it is necessary to send the product for repair, Aqua will provide you
an RMA number (Return Merchandise Authorization) to return your unit.
This number is required to obtain the repair service: any unit received without an RMA
number will be returned to the sender.
The RMA number can be issued only by Aqua staff, you will receive it via e-mail or
other means indicated by you.
Please write the RMA number clearly visible on the outside of the package.
THIRD PARTY CONTENT AND TECHNOLOGIES
In its operation, the device uses or may use some services or technologies provided
by third parties (e.g. streaming services, software applications/libraries and similar).
These services, software applications or products are outside the control of aqua.
Consequently, these services or products are not covered by the warranty. aqua
disclaims any liability relating to them, in particular those related to service
interruptions or malfunctions of the services/products provided by third parties.
GENERAL SAFETY INFORMATION
The following general safety precautions must be observed during all phases of operation
of this equipment. Failure to comply with these precautions or with specific warnings
elsewhere in this manual violates safety standards of design, manufacture, and intended
use of the equipment. Aqua - Acoustic Quality assumes no liability for the customer’s
failure to comply with these requirements.
• DO NOT operate the product in an explosive atmosphere or in the presence of
flammable gases or fumes. For continued protection against fire, replace the line fuse(s)
only with fuse(s) of the same voltage and current rating and type. DO NOT use repaired
fuses or short-circuited fuse holders.
• Keep away from live circuits. Operating personnel must not remove equipment covers or
shields. Procedures involving the removal of covers or shields are for use by service-
trained personnel only. Under certain conditions, dangerous voltages may exist even with
