User Manual Thermal X - R Series Chillers
Page 23
5.
Press OK and the value will flash. Use the up and down scroll buttons to calibrate the sensor
to the thermostat and press OK again
6.
Exit the program
Updating Software
The chiller is dispatched with the latest firmware always installed however should a software upgrade
be required then it can be done simply by installing a USB stick into the USB port at the rear of the
controller.
The firmware will be emailed and it will have a HEX extension at the end of the file. The file will be
U264_32_EB4_XXX.hex. Upload this file onto the USB stick making sure it is the only HEX file in
the root directory of the USB stick.
Insert the stick into the USB port on the rear of the Aqua Cooler controller – the controller will look
for the file automatically and start the upload. The screen will confirm upload in progress and confirm
when it is complete. It should take about 15 seconds. None of the setting in the controller will change
except the feature that the upgrade is improving, adding or fixing.
For units that are connected to the internet or to a BMS system the BIN file will need to be updated
as well to the corresponding issue number. Using a laptop connect to the Aqua Cooler controller via
the Ethernet card in the rear of the controller.
Open a browser with
http://10.1.1.130:8076/mpfsupload
OR if the controller has already been
configured to a unique IP address then use this address. Use the BROWSE key to retrieve the BIN
file saved to your computer or USB key. Once this is uploaded the page will show a tab with “Site
Main Page” on it. Click on this and it will direct you to the main monitoring page for the chiller. The
instructions are above for moving further into the control and monitoring of the chiller.
The IP address of the unit can be found by scrolling to the INFO menu on the home screen of the
controller.
In the parameter menu there is time, date and year menu lines that can be set (see the service section
for instructions) in order that the data log periods and the email alarms are time relevant.
There are other parameters in the programming menu: Some are used in some of the other options.
The setting should not be altered altering the parameters not relevant to the operation of your chiller
may affect its performance and required an out of warranty service call.
