5
SETTING UP YOUR NEW ROBOTIC POOL CLEANER IS AS EASY AS 1, 2, 3!
WARNING: The Power Supply must be placed at least 12 feet / 4 meters from the pool’s edge!
Power Supply
GFCI / RCD
outlet
Floating
Cable
Figure 5d
WARNING: A Ground Fault Circuit Interrupter (GFCI) / Residual Current Device (R.C.D.) must be installed to protect your
electric outlet and to prevent any possible electrical shock!
TIP! To help protect your Floating Cable from potentially getting wrapped around your cleaner’s brushes, it is suggested to
turn off your pool’s filtration system while your cleaner is in operation to reduce the pool’s filter curculation effect that may
push the Cable against the waterline.
Power Supply
Floating Cable
12’ / 4m
from pool’s edge
Make sure that the Power Supply is
positioned at the center of the long
side of the pool that that the cleaner
enters at the pool at its midepoint.
Figure 5c
Figure 5b
NOTE: Please consult this operator manual for further instructions
on how to set its operating time and automatic shut down.
NOTE: It is suggested to unplug the Power Supply when the cleaner
is not in use to protect your cleaner’s unintentional out-of-water
operation due to power surges or accidental pressing of the Power
Supply ON / OFF Switch.
NOTE: Your Power Supply features a Safety Reset Button (Page
8; Fig. 7) to prevent unintentional, “out of water” operation due to
power surges or accidental pressing of the Power Supply ON / OFF
Switch. Press the Switch to ON and then press the Reset Button to
start your cleaner.
Figure 5a
3 Diagonal Positions
Smaller angle allows slower movement when at waterline,
Larger angle provides faster movement.
Handle Spring Lock
Handle Spring Lock