8
INTERNAL TIMED OPERATION
Internal Timed Operation enables owners of Power Supply models equipped with either Dial or Digital
timers to customize their cleaner’s automatic operating cycle to clean anywhere from 1 to 7 hours and then
automatically shut OFF. Once shut OFF the Internal Timed mode will not automatically turn the cleaner back
ON.
1. Press the Main Power ON / OFF switch to the “ON” position.
2. Adjust the Timer Control to the desired cleaning time (1 to 7 hours) depending on suggested cleaning
cycle for your model, pool size and amount of debris in pool (i.e. more debris = longer cleaning time).
Digital Timers (Fig 7): Press the Time Selector Arrows Button upwards to increase time or downwards to decrease operating time.
Each time you press up or down the digital face will display the number of hours of timed operation for.
NOTE: When pressing the Main Power Switch to “ON” should the Green LED above the C-RUN Button blink continuously then the Power
Supply is currently set to the External Timed Operation mode and needs to be reset to the Internal Timed Operation mode by doing the
following. Press and hold the C-RUN Button for approximately 5 seconds until the Green LED stops blinking and remains off. If it has
stopped blinking and is off then the Internal Timed Operation mode is set.
3. Press the Safety Reset Button (Fig. 7). Your cleaner is now set to its Internal Timer and will begin cleaning for the amount of
time set.
NOTE: Your Power Supply will remain in the Internal Timed Operation mode until you physically reset it to the External Timed Operation
mode and will not reset to the External Timed Operation mode even if the power to the Power Supply is turned off or is set to the OFF position.
I
RESET
C-RUN
Digital Timer (Fig. 7)
1. Turn the Main Power ON / OFF
Switch to “ON.
2. Press the “C-Run” (Continuous
Run) button until it is lit.
Your cleaner is now set to
Continuous Run mode.
Figure 7
(Digital Timer)
Safety Reset
button
Continuous Run
(CRUN) button
IMPORTANT: In “Continuous Run” External Timed mode, the Safety Reset button feature becomes inactive and can not
protect models with this feature from accidental “out of water” start up. Therefore, it is imperative that you always unplug
the Floating Cable from its Power Supply when removing your cleaner from the pool!
WARNING: The mode for operating your cleaner should be set after the cleaner has been placed in the pool, the Floating
Cable has been plugged into the Power Supply and the Power Supply has been plugged into the Ground Fault Circuit
Interrupted (GFCI) / Residual Current Device (R.C.D.) protected electrical outlet with the Power Supply located at least
12 feet / 4 meters from the pool’s edge!
Time Selector button
(+1 Second)
Time Selector button
(-1 Second)
Red “ON” LED light
Digital Timer
Display
CONTINUOUS RUN OPERATION (C-RUN)
Continuous Run mode means that the cleaner will operate continuously until the ON / OFF Switch to is physically pressed OFF or an
external time source automatically turns OFF the power to the Power Supply. When manually pressing OFF, to restart its operation
you must physically press the Switch back to ON. For automatic ON / OFF operation in “C-Run” mode, please refer to External
Timed Operation instructions (Page 9).
KNOWING / USING MODEL FEATURES
SETTING THE POWER SUPPLY TIMER (INTERNAL AND / OR EXTERNAL)
Your cleaner has an adjustable Digital timer, which you can set for Continuous Run, Internal (Auto-shut off) Timed Power Supply
or it may be connected to an external, separately purchased timer, such as a house-type timer or pool control system for External
Timed Operation mode where you cleaner can externally be set to automatically turn ON / OFF / ON / OFF as needed.
12
6
3
1
7
5
4
2
12
6
9
3
1
11
10
8
7
5
4
2
