Wether you fill the pressure container or use a bottle (a) with the bottle adapter with water you would
like to electrolyse: Before switching the device on, you should have at least 0,1 Liter of drinking water in
the container. Ideally the container is filled to the top, like this greater hydrogen pressure can build up
and more hydrogen is pressed and dissolved into the water. Keep an eye on the sealed screw fitting and
check or replace the rubber seals, if water leaks, before you start using the device.
Attention: Hydrogen
pressure may not be raised by repeating the electrolytic process more than 30 minutes.
The starting mode requires that the device is operational. The display is illuminated
Pressing the action button once means that operating mode 1 starts (b), which takes 3 minutes.
Pressing the action button twice means that operating mode 2 starts (c), which takes 5 minutes.
When starting an
announcement will commence: “Generating Hydrogen water”
and the blue LED
bubbles start to blink. When finished they switch off with the
announcement “Generating completed”
.
After a finalising tone the display is off. You are able to stop the procedure during electrolysis by pressing
the action button. Also then the announcement and the finalising tone will chime.
a
Attention: Only use still water!
No carbonic acid in the water.
b
c
12 Operating mode
Highdr
ogen
®
Age
2
Go
