Aquallice KRIBA, Quick Start Manual

POOL

FILTER

KRIBA

4.2 Wash

Con el proceso de autolavado procedemos 

a With the valve in the Backwash position, 

the sand inside the filter will be cleaned by 

reversing the water flow direction. Proceed 

as follows:
•   Switch off the pump. Never manipulate 

the valve handle before switching off the 

pump.

•  Press the valve handle until freeing the rib 

form its housing, figure 5.

•  Turn on the handle until the BACKWASH 

position, figure 5.

•  Switch on the pump and let it run for 2 

minutes. Carry out this process until you 

can see transparent water running past 

the valve viewfinder.

•  Switch off the pump

•  Turn on the valve handle to the RINSE 

position. Switch on the pump again and let 

it run for 1 minute.

•  Switch off the pump and turn the handle to 

the FILTER position

•  Switch on the pump and proceed with the 

filtration process.

• 

4.3 Rinse

After the carrying out the “BACKWASH” 

operation on the filter and placing the 

installation in the “FILTER” position, the 

water flowing into the swimming pool will 

be cloudy for a few seconds, so to prevent it 

from reaching the swimming pool there is a 

“RINSE” position for the selector valve which 

is operated as follows: 
•  immediately after the “BACKWASH” 

switched off the pump

•  Turn the valve handle to the “RINSE” 

position, figure 5.

•  Switch on the pump and let it run for 1 

minute.This position ensures that the 

filtered water goes directly to the drain.

•  Switch off the pump and turn the handle to 

the FILTER position

•  Switch on the pump and proceed with the 

filtration process

4.4 Closed

As its name indicates, this position is for 

closing off the water from the filter to the 

pump and it is used for opening the collector 

prefiltre of the pump.

4.5 Recirculation

In this position, the selector valve allows the 

water coming from the pump to go directly to 

the swimming pool without passing through 

the inside of the filter.

4.6 Waste

If the swimming pool needs to be completely 

drained, this can be done using the filter 

pump. In order to do this, the selector valve 

should be placed in the “WASTE” position. 

The motor should run with the main drain 

valve fully open, for the pump to have 

sufficient suction. For the pump to suction, 

keep the main drain pipes full of water. 

Before drainage, make sure that the skimmer 

valves and the bottom cleaner valves are 

closed.
Keep in mind that the pool water will not be 

100% removed, some centimeters will always 

be left. Once the pump does not suction any 

more water, switched it off.