AMG (QLD) Pty. Ltd. Unit 4, 54 Signato Drive, Helensvale, 4212 Queensland, Australia
P a g e
|
2
1.
Introduction
Congratulations on purchasing a state of the art lighting fixture. This fixture uses
LED technology to illuminate industrial areas effectively, whilst minimising
maintenance and power consumption.
Every element of this fixture is optimised to generate greater efficiency than that
offered by conventional solutions, including metal halide and T5 fluorescent.
2.
Installation
To avoid the risk of electric shock, fire or explosion, this fixture should be installed
by a qualified electrician in accordance with all applicable electrical codes.
CAUTION: RISK OF ELECTRIC SHOCK.
Make sure that the electrical power supply is
turned off during installation.
CAUTION: RISK OF ELECTRIC SHOCK.
This fixture must be connected to a wiring
system with an earth/ground conductor.
CAUTION: RISK OF PREMATURE FAILURE
. Make sure that the supply voltage is the
same as the rated fixture voltage.
CAUTION: RISK OF PREMATURE FAILURE.
Operation of the fixture in areas where
the ambient temperature exceeds the maximum rated operating temperature
will reduce the lifetime of the fixture.
CAUTION: RISK OF PREMATURE FAILURE.
To ensure adequate cooling air
circulation, do not install the fixture in a confined space.
The recommended installation heights are: Low Bay < 6m and High Bay 6-12m.
Hook Mount
The fixture must be vertically suspended. The method of suspension (chain
etc) must be able to support at least 5 times the total weight of the fitting. Do
not install where wind will make the fitting swing about, causing wear and tear of
attachment points. Fixtures should be installed where access for maintenance is
practical and in accordance with any lighting design information provided
for the installation.
