Technical information:
Length (cm) : model-230 230cm, model-260 260cm, model-330 330 cm, model-430 430cm
Width (cm) : model-230 127cm, model-260 160cm, model-330 151cm, model-430 175cm
Tube diameter : model-230 33cm, model 260 41cm, model-330 41cm, model-430 50cm
Nr of chamber : 2
Max Persons : model-230 1+1, model-260 1+1, model-330 1+2, model-430m 1+3
Capacity (kg) : model-230 175kg, model-260 250kg, model-330 400kg,. model-430 500kg
Max motor capacity : model-230 5HP, model-260 5HP, model-330 15HP, model-430 20HP
Category : model-230 built as per Category-D, model 260, 330 and 430 : Category-D
Assembly:
General procedure
1. Remove any sharp objects from the area where the boat will be assembled and inflated.
2. Unfold and spread out boat flat.
3. Slide each slatted floor board into its floor passing through opening.
4. Half inflate the boat with foot-pump or electric pump first.
5. Position bench seat(s)
6. Fully inflate.
7. Check the valves and close carefully to make sure there are no leaks in valves.
Floorboard Assembly Instruction
Slide each slatted floor board according to following pictures:
NOTE: Make perfectly sure that each floor board is well centred, as it will be difficult to reposition the board
once the boat is fully inflated.
