INSTALLATION INSTRUCTION
A
Ensure to check all parts are present:
a.
Spa pool
b.
PU cover with foil and zipper
c.
Inflation hose
d.
Filter cartridge
e.
Filter cartridge cover
f.
Rubber plug
g.
Repair kit
B
Site requirements:
WARNING1: The floor has to be capable of supporting the expected load.
WARNING2: An adequate drainage system has to be provided to deal with overflow water.
IMPORTANT:
Because of the combined weight of the spa, water, and users, it is extremely important that the base where the spa is installed is
smooth, flat, level and capable of uniformly supporting this weight for the entire time the spa is installed. If the spa is placed on a surface, which
does not meet these requirements, any damage caused by improper support will void the warranty. It is the responsibility of the spa owner to
assure the integrity of the site at all times.
a)Indoors installation:
Be aware of special requirements if you install the spa indoors.
1.The floor must be able to withstand the capacity of the spa. The floor should be a non-slip, level surface.
2.Proper drainage is essential for indoor spa installation. When building a new room for the spa it is recommended that a
floor drain be installed.
3.Humidity is a natural side effect of spa installation. Determine the effects of airborne moisture on exposed wood, paper,
etc. in the proposed location. To minimize these effects it is best to provide plenty of ventilation to the selected area. An
architect can help determine if more ventilation is needed.
NOTE:
Do not install the spa on carpet or other material that can be damaged by moisture.
!
!
!
a
b
c
!
!
!
!
d
e
f
g
Figure a
Summary of Contents for SPA550
