!
!
Base of the controller is made of environmental-friendly PU material that is soft and comfortable. Surface of the base can be washed.
The controller is chrome-plated, which meets ROHS standards.
Surface films are glued to the controller by marine glue.
Body of spa:
!
!
1.
Air inflation of water tank body: air pressure for air inflation of water tank body is indicated by the green area of the pressure gauge. If air
pressure does not reach the green area, air inflation can continue until reaching the green area. If air pressure goes beyond the green area, please
stop the air inflation.
2.
Water filling of water tank body: water should be filled to a position 20mm higher than the water line. If lower, heating may not be realized. If
higher, water may spill over the tank in use.
3.
Maintenance of water in the water tank body
3.1
Water in the water tank body should be filtered at fixed time regularly. It is not suggested to filter the water at all times.
3.2
Water in the water tank body should be treated with chemical agents periodically. However, chemical agents with calcium ions must not be
used. If chemical agents with calcium ions are used for water treatment, there will be very likely to form scales on the walls of water tank and inner
Summary of Contents for SPA550
