1. Tear the label and open the water bottle.
2. Carefully, with two hands, insert the bottle into the bottle supporter on top of
the machine. Do not plug the power cord or turn on the red switch until 3
minutes after you put the full water bottle.
3. Insert the plug into the socket, and then turn the power switch on. The
indicator light lights up accordingly once the machine is working. The light will
turn automatically off when the water reaches the rated temperature.
4. When the water bottle is empty, pull out the bottle with two hands; then
replace it with a full bottle of water.
5. If you want to drink hot water, press the heating switch. If you
want to drink cold water, press the cooling switch.
1. Keep this machine in a dry and cool place avoiding
direct sun light. The back of the machine should be at least
8 inches from the wall. Never put the machine on paper or
foam; this may cause unstable conditions as accumulated
water or cause Electrical leakage. Never put anything
flammable beside this machine.
2. To avoid damage to the machine, do not plug the power
cord or turn on the heating switch (red) until at least 3
minutes after you place the full water bottle.
3. In case hot (or cold) water will not be needed for a long
time, turn off the switch to save energy.
4. This water dispenser must be used with a three-prong
grounding plug and Electrical leakage protection switch. If
a two flat prongs plug is used, the grounding wire must be
properly grounded before use.
5. In this machine is not going to be used for a long time,
turn off the switch, pull the plug out from socket and drain
the remaining water through drain hole.
6. Never use organic liquids to clean the machine. Do NOT
splash water to the body of the machine.
7. You should always use the On/Off switch to turn on or off
the machine. It is prohibited to turn on or off the machine by
plugging or unplugging the power cord. Never extend the
length of the power supply cord to avoid fires.
8. For this model dispenser (with compressor), never turn the
o
machine upside down or tilt it more than 45 .
9. Since this model dispenser thermostat has been factory
adjusted, please do not try to adjust it by yourself.
10. This machine should not be turned on until at least 3
minutes after plugging the power cord or after turning off the
cooling switch (blue button).
11. The power cord or other parts must be replaced only by
professional technicians when it is damaged.
12. We reserve the right to revise this instructions manual.
To avoid accidents, cut off the power supply before cleaning
according to the following instructions.
1 The machine has been disinfected before shipping from the factory. Before
using this machine for the first time, clean the machine by pressing the hot
water tap and cold-water tap, and letting about 1 liter of water to flow out.
2. The machine should be disinfected with the disinfectant available from the
local market according to the instructions of the disinfectant, and then cleaned
with water.
3. Have the bottle supporter, water tank and heating element cleaned by a
professional about every year. This will keep the machine in good condition
and extend its life. Never disassemble this machine by yourself to avoid
damaging the machine.
4. Draining instructions: open the taps and
away the cap and rubber
stopper from the water outlet on the rear side of machine.
5. Use any neutral soft cloth to clean the surface of the machine.
.
take
