Shenzhen Aquarobotman Innovative Technologies Co., Ltd.
Professional Underwater Integrated Solutions Provider
Temperature: water temperature should be between -2°C to 35°C.
Water depth; 0 - 100 meters.
Water environment: no obvious aquatic pants or other obstacles
Things to Inspect Before Using
1.
Main unit
a)
Check to see if the main unit's protective rack is installed.
b)
Check to see if there are foreign objects attached to the camera lens.
c)
Check to see if anything is tangled in the thrusters on each propeller.
d)
Ensure that any camera filters you would like to use are properly attached.
e)
Check to see if the KEVLAR signal line is clean and free of debris.
f)
Check to see that the battery chamber and the electrode mounting slot are free of debris.
2.
Wi-Fi base station
a)
If you have a reel, check to see if it rotates properly.
b)
Check that the Wi-Fi base station's power switch is working properly and that the power indicator
light is illuminated normally.
c)
Check if the cable is damaged.
Post-use Maintenance
The user should perform the following maintenance tasks after using the drone.
a)
Rinse or soak the main unit with freshwater (soak with the battery installed).
b)
Use fresh water to wash the reel and KEVLAR cable.
c)
Remove the battery from the main unit and turn off the power supply for the base station to
prevent the battery from excessive discharge.
Media Data Export
The front half of the drone must be immersed into cold water (as shown in the figure below) while
exporting original data from the drone’s internal memory. This is to prevent it from overheating.
Possible issues:
Possible issues:
Solution
1
Not washing the drone with fresh
water after retrieving the drone
from the sea causing a layer of salt
to form on the drone surface
Put the drone in fresh water for a while and wait until the salt
dissolves off the surface.
2
Drone got wrapped in aquatic Remove the drone from the water and remove the aquatic
Summary of Contents for NEMO
Page 1: ...NEMO User Manual V1 4 ...
