5. Press new replacement filter to the top of the filter
housing using the appropriate color coded filters.
Then, reconnect the bottom of the filter housing to
the top half. Ensure connection points are correctly
aligned, then turn clockwise to tighten. Continue this
step for each filter housing.
6. Reattach filter housing to bottom of the system manifold. Ensure
connection points are correctly aligned, then push the filter
housing up while turning clockwise. Continue this step for each
filter cartridge. Ensure all filter housings are not at an angle while
reattaching. This may result in damage to the o-ring.
7. Open battery door and remove old battery. Insert new battery. When inserted
correctly, system will beep five times and blink red.
8. Once all filter housings have been replaced and attached, slowly turn water valve
on. Turn off faucet and inspect for leaks. Then, flush system for 10 minutes before
drinking.
2
FILTER REPLACEMENT
8
FILTER REPLACEMENT
9
Once filters are at 95% capacity (about every 6 months), the battery alarm will
sound when water is flowing then will continue to sound for 15 seconds after
water is turned off. The battery will need to be replaced every time the filters
are replaced. A battery is included with the filter replacement cartridges.
1. Shut off the cold water valve under the sink. Release the pressure from
the system by turning on the dedicated faucet. Once there is no longer
any water flowing, you can proceed with replacing the filters.
2. Unbox filter replacements and remove plastic. Each filter is color coded
to match the circle indicator on each filter housing.
3. Remove each filter housing from the system manifold
by turning the filter housing to the left. Pull down to
detach. Ensure the filter housing are not on an angle
while removing. This may result in damage to the o-ring.
4. Holding the filter housing over the sink, open it by
turning the bottom counterclockwise. Pour excess water down sink drain.
Pull down on dirty filter to disconnect it from the filter housing. Continue
this step for each filter housing. While the
housing is open, inspect each o-ring for
damage. If misaligned, gently move
the o-ring into place.
NOTE: If filter housing is too tight to
disconnect by hand, please use the plastic
wrench included with original system.
NOTE: Do not use tools to
tighten. Hand tighten only.
NOTE: The filter housing must be replaced
every five years. Failure to do so could
result in potential leaks due to product
deterioration. To order, please call
Customer Support at 866-662-6885.
NOTE: Do not drink flushed water.
A
B
B
A
AQ-5200
Red • Yellow
AQ-5300
Black • Red • Yellow
AQ-5300+
Green • Red • Yellow
AQ-5200R
Scan to view AQ-5200R
replacement video.
AQ-5300R
Scan to view AQ-5300R
replacement video.
AQ-5300+R
Scan to view AQ-5300+R
replacement video.
