Follow the SET-UP procedures below, upon FIRST USE of the transmitter.
INITIAL SET: Push and hold SET button for more than 5 seconds and then
release button for initial set-up. A beeping sound will be heard. The initial settings
include settings for TIME, °F/°C conversion, DAY of the Week, BALANCING and
WATTAGE of Water Heater.
A.
SETTING CURRENT TIME: Following the
push of the SET button in the step above, the
HOUR digits will begin blinking in the TIME
window. Press the UP/DOWN buttons to set
the current HOUR, in the corresponding
AM/PM time period. Press SET button again
and the MINUTES will begin blinking. Press
the UP/DOWN buttons to set the current
MINUTES. Press the SET button again and
the °F/°C will begin blinking
.
C. SETTING THE TEMPERATURE SCALE:
Press
the UP/DOWN buttons to change the
°F/°C scale. (Factory setting is °F). Press
the SET button again. The icon S will begin
blinking prompting the user to enter the
current DAY of the week.
22.
D. SETTING THE DAY OF THE WEEK:
To change to the current DAY of the week,
press the UP/DOWN button to display
current DAY. The press the SET button and
the BALANCING window will begin blinking.
IMPORTANT NOTE: If you are not able to preform the next 2 SET-UP proceedures
within the next 30 seconds, the transmitter will return to its NORMAL STATE.
When you are ready to restart the SET-UP again, press the SET button for 5
seconds, release button and scroll to CRITICAL ADJUSTMENTS #1 and #2
pressing the SET button several times and prepare to enter the required data.
# 1 - BALANCING THE THERMAL SENSOR
PREVIOUS INSTRUCTIONS, ON PAGE 6, RECOMMENDED THAT YOU RECORD THE
WATER TEMPERATURE FROM THE THERMOMETER STRIP.THIS IS THE READING THAT
IS TO BE ENTERED IN THE SENSOR TEMP WINDOW ON THE TRANSMITTER’S LCD.
A small THERMOMETER STRIP has been supplied to allow user to measure the
ACTUAL temperature of the hot water coming out of a water faucet supplied by the water
heater. During the initial set-up process, user MUST adjust the SENSOR TEMP to the
actual water temperature coming from a HOT water faucet in the home. From a faucet
nearest the hot water heater, fill a glass with hot water and drop the temperature strip
into the water. Observe the mid- temperature strip reading on the temperature strip
comparing this reading in the SENSOR TEMP window on the Transmitter’s LCD screen.
TEMPERATURE STRIP IN GLASS OF HOT WATER
TEMPERATURE STRIP
Using the UP / DOWN buttons, adjust the
SENSOR TEMP temperature reading on the
LCD screen to closely match the temperature
of the HOT water coming from the water
faucet. The “BALANCING” numbers will
display in both the SENSOR TEMP and
SENSOR TEMP SET windows on the LCD
screen during this process. Press the SET
button to hold the new BALANCED
temperature reading.
23.
UP
DOWN
SET
TWO IMPORTANT SETTINGS MUST BE MADE OR THE SYSTEM
WILL NOT ACCURATELY CALCULATE THE TEMPERATURE DATA
AT THIS TIME, IT IS RECOMMENDED THAT THE USER REVIEW
THESE TWO SET – UP PROCEEDURES SO THAT DATA IS READY TO BE
ENTERED INTO THE TRANSMITTER, WHEN PROMPTED.
#1 – BALANCING THERMAL SENSOR TEMPERATURE
#2 – WATER HEATER WATTAGE RATING
INITIAL SET – UP & PROGRAMMING OF THE TRANSMITTER
