Tel: 1-800-661-0680
6
www.
AQUASURE
USA
.com
STEP 4.
Attaching the Water Supply Pipe
1. Wrap the 1” male threaded fittings (Not Included) with 5 to 6 wraps of Teflon tape.
2. Attached the 1” male threaded fitting from the incoming supply plumbing to the
IN
port
and
OUT
port of the system.
STEP 3.
Mounting the System
1. Position the system on the wall at the desired mounting location with minimum of 6 in
ground clearance from the floor to the base of the system.
2. Using a pen or pencil and mark the mounting hole on the back of the bracket onto the
wall.
Note:
Please make sure the bracket mount is leveled using a leveling tool to ensure evenly
distributed stress on the bracket. Make sure the mounting point is position on a stud to
properly secure the bracket.
3. Mount the system onto the wall using the provided Lag Bolt and Washer.
