15
FILL-UP AND START-UP INSTRUCTIONS
The following procedures should be followed on initial startup and whenever the spa is drained for
routine maintenance.
FILLING THE SPA WITH WATER
1. Clear all the debris from your spa.
2. Be sure to open all jets to allow as much air as possible to escape from the plumbing during
the filling process.
3. Insert a garden hose into filter
compartment to fill your spa.
NOTE:
Do not use hot or softened
water.
4. As the water level rises, check
inside the equipment compartment
for water leaks. It may be
necessary to tighten unions and/
or fittings that may have loosened
during delivery. There is no need
to call for service; this can easily
be done. If assistance is required,
contact a Customer Service
representative at (888) 961-7727
Ext. 8440
5. Under normal circumstances keep
the water level half way between
the top of the spa and the top of the gray filter ring or just above the highest jets (whichever is
higher).
Failure to keep enough water in your spa may result in damage to your system and invalidate
your warranty. If your spa filter is sucking in air causing the pump to cavitate, you need to add
water!
6. Check the filter installation and make sure the filter is not loose.
APPLYING POWER
1. Turn power to spa "ON" (after filling spa) from the main panel at the house and the subpanel.
2. Press the
Jets
button on the topside control panel to activate the spa. Rotate all the air control
valves counterclockwise and observe the increased jet action (air mixed with water).
3. While the pump is running check again for water leaks at the drain spigot, unions, or fittings in
the equipment compartment (leaks may have occurred during transit). If water is leaking from
one of these areas, there is no need to call for service. Simply tighten the fitting. If assistance
is required, call a Customer Service representative at (888) 961-7727 Ext. 8440.
4. After checking your spa for leaks it is now time to adjust your spa settings. Press the
Plus
or
Minus
button on your topside control panel until the display indicates your desired temperature
is set.
UNIONS
Summary of Contents for Aryana
Page 1: ...OWNER S MANUAL 110V 230V 60Hz Models 303556 21 A 9 20 ...
Page 48: ...MANUAL DEL PROPIETARIO Modelos de 110 V 230 V 303556 21 A 9 20 ...
Page 49: ...MANUAL DEL USUARIO Modelos de 110 V 230 V 60 Hz 303556 21ES A 9 20 ...
Page 73: ...MANUEL DU PROPRIÉTAIRE Modèles 110 V 230 V 60 Hz 303556 21FR A 9 20 ...
