AquaTerra Fairfax, Owner'S Manual

14

COMPONENT OPERATION

SPA COMPONENT OPERATION

AIR CONTROL VALVE

The air control valves (smaller valves) serve to regulate the amount of air mixed with the water 

when the jets are operational. Turn the air control valves in one direction to increased jet action. 

Rotating the air control in the opposite direction to turn air off and allow the jets to work with water 

only. Turn the air controls off when the spa is not in use, this will prevent cold air from entering the 

spa and will keep heating cost to a minimum. The ozone jet, will always produce air bubbles when 

pump is on.

DIVERTER VALVE 

The diverter valves (larger valves) on your spa allows you to direct the flow of water to one of the 

jet flow combinations. Your spa has two pumps and two diverter valve, each diverter valve works 

with one pump. The function of the diverter valves can best be learned by experimentation.  Turn 

the large valve completely to one side to see which jets are on, then turn completely to the other 

to see which jets are affected if nothing seems to happen than try the other diverter valve.  (You 

can adjust the diverter value to any position between the two possible extremes to achieve the jet 

pressure that feels best to you).

IMPORTANT

:  Your spa is not designed to provide full power to all jets when the diverter valves are 

in the “mid” position. However with the diverter valve in this position, you may increase the power 

to selected jets by rotating the faces of the hydrotherapy jets to close the ones that are not in use.

HYDROTHERAPY JETS 

The hydrotherapy jets are recessed in the wall of the spa. Rotate the large or medium jet faces to 

turn the jets on or off. Turning a jet on or off will increase or decrease the effects of any jets not in 

the closed position.

OZONE GENERATOR 

The ozone system enhances the quality of the spa water when used to supplement the spa 

owner’s regular water maintenance program. Contrary to some information circulated throughout 

the pool and spa industry regarding ozone systems, ozone 

CAN'T

 be used as a single-source 

sanitizer, water clarifier, anti-foamer, and mineral chelating agent. A secondary source sanitizer 

must be used to maintain 3.0 -5.0 ppm of Free Available Chlorine (FAC). AquaTerra recommends 

that a chemical maintenance program based on recognized and documented industry standards 

still be followed when using an ozone purification system to assure water sanitation and the 

highest quality purified water.

WATERFALL 

Your spa has a control valve to operate the amount of flow through the waterfall from no flow to a 

steady stream.  This valve is attached to the top and bottom of the waterfall. The waterfall will only 

work when Jet Pump 1 is on. Move valve side to side to turn on or off.

MUSIC 

You spa is equipped with a Bluetooth music sound system that requires a bluetooth device to pair 

up with the the spa. To pair the spa and Bluetooth device:
•  Go to the Bluetooth settings on you device and find 

in.stream 2 

and press connect.

•  Enter pin 

5555

 and press pair to sync your device. You are now ready to play audio from your 

device.