— 3 —
Aquatic Bath • 8101 E. Kaiser Blvd., Anaheim, CA • (800) 945-2726 • www.aquaticbath.com
Check dimensions.
NOTE: If you’re adding additional accessories such as a grab
bar–additional framing or backing may be needed for support.
Pre-install unit to ensure framing pocket is plumb, square, and a level installation can be achieved.
(See steps 3 and 4.) Adjust framing as needed – shim where necessary.
Additional stud will be required for vertical backwall flange. Stud @ 6-1/2” CL from back,
on both sides. Stud can be turned for easier installation.
6"x12"
A AAA
C
C
D
D
B
B
11
6-1/2"
CL
22
Level and mark all sides. Front apron should be firmly on the floor.
NOTE: If unit is not level, the joints and seams will not align properly.
44
Lift and place the back wall.
55
Lift and place the base into framing.
33
Models
A
B
C
D
6030SPAN
6030SPANM
60
1
⁄
8
”
(1527mm)
31
1
⁄
4
”
(794mm)
8
1
⁄
2
”
(216mm)
14
1
⁄
4
”
(362mm)
6030STUB
6030STUBM
60
1
⁄
8
”
(1527mm)
31
1
⁄
4
”
(794mm)
2”
(51mm)
13
7
⁄
8
”
(353mm)
Pre-Installation Instructions
*Review Tech Data at aquaticbath.com for more detail.
NOTE: 6030SPAN is shown for illustrational purposes.
Installation Data
160304PSL/R, 160304PSML/R,
260304PSL/R, 260304PSML/R
Fax on Demand # 9034
