— 7 —
Aquatic Bath • 8101 E. Kaiser Blvd., Anaheim, CA • (800) 945-2726 • www.aquaticbath.com
Clean unit. Apply a strip of painter’s masking tape along the inside
edge of each side of the seam where silicone sealant will be applied.
Apply silicone to the joints/seams and smooth over with finger or
caulking tool. While the silicone is still wet, remove tape strips along
joint edges.
NOTE: Allow silicone to cure for 24 hours (normal cure
time) before using bath or shower. Humidity affects the curing process
and different geographical areas experience varying degrees of
humidity. Refer to silicone manufacturer’s instructions for additional
information related to curing times.
27
27
Apply silicone along horizontal and inside vertical edge.
Slide side wall into position.
25
25
Fasten flanges along top of left side wall with fasteners of choice
(see Pre-Installation Planning #12) into each corresponding stud. Fasten
side (vertical) flanges to side studs 8” (200mm) on center.
26
26
Fasten flanges along top of right side wall with fasteners of choice
(see Pre-Installation Planning #12) into each corresponding stud. Fasten
side (vertical) flanges to side studs 8” (200mm) on center.
24
24
Installation Data
160304PSL/R, 160304PSML/R,
260304PSL/R, 260304PSML/R
Fax on Demand # 9034
