The 6500-885 includes the universal harness AQ-UNH-2 in order to connect the dock to
power and speakers.
All open wire connections should be soldered and protected against water and dust for best long
term performance.
1.3 12-pin Harness Connection
Media
Supported media....................................
Supported media max. dimensions...........
Inputs
Auxiliary................................................
Outputs
Pre-Out..................................................
Power
Output voltage @ 2 Ohm.........................
Output voltage @ 4 Ohm.........................
Operation voltage....................................
Max current draw....................................
Standby current draw..............................
Multi-Environment Certifications
Waterproof / Dustproof............................
Conformal PCB coating...........................
UV protection.........................................
Salt/Fog protection.................................
Stainless Steel mountings.......................
Bluetooth/MP3
107 x 184mm (WxH)
1x 3.5mm Stereo Jack Socket, 1x Stereo pair RCA input
2x Stereo pair RCA (4V)
4x 72W
4x 45W
9.6V - 14.4V DC
7A
6mA
Yes IP65 (Remote Control rated IP66)
Yes
500 hours stable, ASTM D4329 compliant
500 hours stable, ASTM B117 compliant
Yes
6.1 Speci
fi
cations
No lower than a 2 Ohm load should be used
or damage may occur to the Digital Media
Locker.
Make sure the polarity of speakers are
connected correctly.
Power Antenna (7)
Fuse Box
No lower than a 2 Ohm load should be used
or damage may occur to the Digital Media
Locker.
Make sure the polarity of speakers are
connected correctly.
(White/strip)
Getting Started
Digital Media Locker 6500-885
Specifications & Dimensions
Digital Media Locker 6500-885
13
www.aquaticav.com
www.aquaticav.com
1. A mounting template is included. Aquatic
AV recommends using the ‘measure twice, cut
once’ method!
2. Once the mounting hole is complete, make
sure the outside surface is clean and clear of
debris. The Digital Media Locker has an exter-
nal water/dust proof gasket, but this requires
3. The Digital Media Locker has six (6) front
screws. Drive the screws using a screw driver.
all points for the best water/dust outer seal per-
formance. Make sure screws are snug and do
not over tighten.
4. Review all outside surfaces of the Digital
Media Locker to ensure proper water/dust seal.
This is important for long term environmental
protection performance for your digital media
device.
1.4 Mounting the Digital Media Locker
194mm
118mm
95mm
66.8mm
4
7
1
4
