Aquatic
12
Elements Series Owner's Manual & Installation Guide
INSTALLATION INSTRUCTIONS
DECK CUTOUTS
A paper template will be enclosed with all rounded-edged models. Use the directions on the paper template for cutout
dimensions.
If the paper template has been lost or needs replacement, please contact Customer Service at:
800.945.2726.
USING THE CUTOUT TEMPLATE
Draw a center line horizontally and vertically on a 1” thick plywood deck. Place the template in the upper left hand
quadrant, noted as Quadrant 1 on the diagram below. Trace template to outline Quadrant 1. Flip the paper cutout horizontally,
making sure to match the dotted center line on the template with the center line on the plywood. Trace again to outline
Quadrant 2. Repeat until the remaining quadrants of the cutout have been traced.
CORNER MODELS
On a 1” thick plywood deck, place the template in the
upper section noted as Section 1 in the diagram. Trace
Section 1 to establish the centerline and front edge of
the cutout. Flip the template along the centerline and
trace to complete the other half of the unit noted as
Section 2 in the diagram below.
RECTANGLE MODELS
Using a 1” thick plywood deck, the cutout should be 2”
smaller than the overall tub dimensions (length & width),
for 1” overhangs on all sides. For example, a 72” x 42”
unit should have a deck cutout of 70” x 40”. Additional
dimensions can be found in the technical data sheets at
www.aquaticbath.com.
