32 Aquatic
Serenity Owner's Manual & Installation Guide
TUB CARE
MAINTENANCE
Use common household, non abrasive cleaners for most cleaning jobs. Clean grease, oil, paint and ink stains with Isopropyl
(rubbing) alcohol. Rinse well and dry with a clean cloth or sponge. Do not run the air system with foaming cleaners or
soaps. Rinse the bath thoroughly after cleaning. Do not allow your Lucite® acrylic surface to come into contact with products
such as acetone (nail polish remover), nail polish, dry cleaning solution, lacquer thinners, gasoline, pine oil or other toxic
and oily cleaners.
FLUSHING / SANITIZING
Before tub is used, your air bath and plumbing system should be flushed. Close the drain. Fill bath with hot water to at least
six inches above air injector holes. Add 4 – 6 tablespoons of low sudsing automatic dishwashing detergent and no more
than 24-48 ounces of bleach to the water. DO NOT use splashless bleach. Turn bath on for approximately two minutes to
mix cleaner with water. Shut blower down and allow cleaner to soak in the bath for approximately two hours. Turn on air
bath and run for approximately five minutes. Turn air bath unit off and drain tub. Aquatic recommends the above cleaning
process on your air bath once a month.
SURFACE SCRATCH REMOVAL
Minor scratches may be removed by polishing your tub with a non-abrasive car polish, followed by buffing. Deeper scratches
can be removed by:
• Sanding with wet 400 grit sandpaper.
• Sanding with wet 600 grit sandpaper.
• Sanding with wet micro-grit sandpaper.
• Buff out using car polish.
REPAIR
The installation and service of your air bath should be performed only by a qualified service technician. Remember when
contacting your distributor always have your serial number, proof of purchase and model number available. This will ensure
a quick response on warranty items. See page 3 for serial number location.
NOTE:
ALL WARRANTY REPAIRS MUST BE AUTHORIZED BY AQUATIC BEFORE WORK IS STARTED. FOR SERVICE, ALWAYS
CONTACT YOUR DISTRIBUTOR OR AUTHORIZED SERVICE CENTER.
CAUTION:
Care should be taken to prevent inappropriate chemicals coming in contact with the Lucite® acrylic surface.
Please read and observe all instructions and/or warnings on containers containing substances you contemplate applying
to your air bath. Any failure to comply may void your warranty.
WATER AND AIR TEMPERATURE
Each Serenity model is equipped with a 600 watt air heating system to raise the temperature of the air going into the
bath. This air temperature will be less than the bathing temperature of the water, but will help to reduce a rapid decrease
in water temperature. In addition, the air coming from the air jets will feel cool against the skin, just as a breeze on a
warm day cools your body. This system does not heat the water.
