20
Aquatic Industries, Inc.
OPERATION of
MILLENNIUM SERIES
UNIVERSAL REMOTE CONTROL:
LEARNING MODE:
The Universal Remote has the ability to learn new functions from your original remote controls.
Note:
To optimize success, the learning process should be conducted in an area where there is a low level of IR emission.
High levels of natural light or energy efficient florescent lights could interfere with a learning event. The source and
target remote should be no more than 1 to 2 inches apart during a learning event and the IR LED's of the two units
should be aligned with each other. It is important to use new batteries on the source remote. (Refer to page 21 to
read limitations about the learning mode.)
The learning operation is initiated as follows:
1. Press and hold
setup
until LED blinks twice to initiate learning mode, then release key.
2. Enter
9
-
7
-
5
. LED will blink twice. Remember to press and hold
shift
key first to access numbers (
0
-
9
).
3. Press mode key (
tv
,
video
,
aux
or
bath
).
4. Hold teaching remote close to LED.
5. On the Universal Remote, press key to be learned. LED flashes rapidly.
6. Press and hold key to be taught until LED on universal remote blinks twice.
7. LED turns off.
8. Repeat steps 3-7 as often as desired (up to limit of memory).
9. Exit learning mode by pressing and holding
setup
until LED blinks twice, or by time-out (if remote remains
untouched for more than 10 seconds).
Note:
•
At step 6, one long blink indicates learning failure, which could be:
–
Bad capture (try again)
–
Memory full (delete some other function, see page 21)
–
Unlearnable code
•
At step 2, one long blink indicates low battery or memory full (i.e. the unit will not go into Learning mode
if either of these conditions exist).
•
If your memory is full, delete one function (setup, 9, 7, 6; see page 20) or delete all (setup, 9, 8, 1 or
9, 8, 0; see page 21).
DELETING A LEARNED FUNCTION:
If your memory is full, you will need to delete one or more functions on your Universal Remote. Here is how to delete
one function:
1. Press and hold
setup
until LED blinks twice, then release key.
2. Enter
9
-
7
-
6
. LED will blink twice. Remember to press and hold
shift
key first to access numbers (
0
-
9
).
3. Press mode key once (
tv
,
video
,
aux
or
bath
).
4. Now press twice on the key you want to delete. Learned function reverts to original function.
Note:
The LED blinks two times after successful completion of deleting sequence. There will be 2 blinks and one long blink
if there is a problem with the remote. Remote goes back to normal operation after 10 seconds.
