Aquatic Industries, Inc.
9
1. After securing bath in place, normal waste and overflow and valves are installed per normal plumbing procedures,
in accordance with all state and local standards.
2. Install standard 1-1/2" trap to drain and overflow. Before proceeding make final operational check by filling tub
with water to overflow and operate pumps for 5 minutes. Check for leaks carefully both while pump is running
and has been turned off. Allow water to stand in tub for at least 30 minutes before draining.
AQUATIC INDUSTRIES, INC. WILL NOT BE RESPONSIBLE FOR WATER DAMAGE OF ANY KIND IN CONNECTION
WITH ONE OF OUR WHIRLPOOL BATHS.
Aquatic recommends the use of 3/4" valves.
3. All Millennium Series models are equipped with an integral Fast-Fill Waterfall Spout (unless ordered without this
feature). Purchasing a spout is unnecessary, however, hot and cold water valves are needed. Valves can be
mounted where you choose, however, if installation is to be on tub deck, check the back side of the tub for adequate
space for connection to water lines before drilling or cutting tub.
PLUMBING:
INSTALLATION INSTRUCTIONS
FAST-FILL WATERFALL SPOUT:
Fast-Fill Waterfall Spout
is stubbed out with a 3/4" female
threaded PVC fitting.
The Fast-Fill Waterfall Spout will be stubbed as in Diagram 3C.
WARNING:
DO NOT OVER TIGHTEN! DO NOT USE TEFLON TAPE. Damage to fitting is not covered under warranty.
3B
FROM VALVES
See Diagram 3A, below
MODEL
A
B
Millennium VII
2 1/4"
31 1/2"
Millennium VIII
6 1/2"
41"
Millennium IX
3 1/4"
35"
Millennium X
5 3/4"
26"
B
A
ROUGH-IN MEASUREMENTS:
3A
PLEASE NOTE: THE MANUFACTURER ACCEPTS A 1/4” VARIANCE. THERE ARE
VARIATIONS ON EACH TUB AND SPECIFICATIONS ARE SUBJECT TO CHANGE AS
WE IMPROVE UPON OUR PRODUCT AS REQUIRED.
THE DIMENSIONS NEEDED FOR SITE PREPARATION AND STRUCTURE
BUILDING SHOULD BE MEASURED FROM THE TUB; AQUATIC INDUSTRIES, INC.
ASSUMES NO RESPONSIBILITY FOR PREPARATORY WORK.
3C
