Aquatic 19
Serenity Owner's Manual & Installation Guide
INSTALLATION OF FREESTANDING MODELS
NOTE:
• Freestanding units must be placed on a perfectly leveled floor.
• The blower must be mounted in a remote location and cannot be installed on the bath.
• Wall mounted or freestanding faucets must be used.
Serenity 10 & 37 Installation
For information on electrical installation, maintenance and care,
troubleshooting and warranty, please refer to the Table of Contents.
Before the floor installation is complete, make sure it is perfectly level.
Once the floor installation is complete, determine the exact location of
the bath and mark the floor position of the four claw feet (see Diagram 2A).
To help prevent the bathtub from shifting, we recommend the bathtub legs to
be anchored to the floor. Also, mark the position of the holes to be drilled for
the blower air passage and drain.
1. Drill a 2” hole for the air passage and 2” hole for the drain.
2. Install the drain and overflow on the bath. Cut pipes to desired length
prior to assembly. Next, glue the first section of pipe (PVC 1 1/2”) to
the air passage under the tub and then cover the pipe with the pipe
concealer (see Diagram 2B).
INSTALLATION INSTRUCTIONS
FREESTANDING MODELS
Diagram 2B
Pipe Concealer
Cut pipes to desired
length prior to assembly
SERENITY 10 BOTTOM VIEW
SERENITY 37 BOTTOM VIEW
Blower Fitting
Diagram 2A
Blower Fitting
14"
9"
TOP VIEW
6" x 6"
BOX OUT
DRAIN HOLE
13"
9"
TOP VIEW
6" x 6"
BOX OUT
DRAIN HOLE
SERENITY 10 TOP VIEW
SERENITY 37 TOP VIEW
Summary of Contents for SERENITY W6AIR6060
Page 86: ......
Page 87: ......
Page 88: ...Customer Service 800 945 2726 aquaticbath com 8MANDBTH 01 17...
