Aquatic 29
Serenity Owner's Manual & Installation Guide
INSTALLATION INSTRUCTIONS
FREESTANDING MODELS
REMOTE CONTROL (FREESTANDING)
Receiver Module and remote may be used in conjunction with supplied keypad or without.
Remote Control and Keypad Used to Activate the System
1. Plug the 25' cable into the blower and the 12" cable into the keypad.
2. The receiver module needs to be mounted within 16” of the keypad.
3. Install the receiver module 6' – 10’ from point of use.
4. Once everything is connected, the remote control is ready for synchronization.
Remote Control Only to Activate the System
1. Plug the 25’ cable into the blower.
2. Install the receiver module 6' – 10’ from point of use.
3. Once everything is connected, the remote control is ready for synchronization.
Synchronization
1. Once the system has been connected, the remote control must be synchronized with its receiver module.
2. Switch off the main breaker or unplug the system and switch it on again.
3. From this moment you have 15 seconds to proceed with the synchronization.
4. Press simultaneously on buttons 1 & 2 of the remote for 4 seconds as
shown in Figure 11.
5. The remote copntrol is now synchronized and ready for use.
6. If the synchronization is not successful the first time, you should resynchronize,
starting from step 2.
Figure 10
Summary of Contents for SERENITY W6AIR6060
Page 86: ......
Page 87: ......
Page 88: ...Customer Service 800 945 2726 aquaticbath com 8MANDBTH 01 17...
