Aquatic 31
Serenity Owner's Manual & Installation Guide
OPERATION
NON-FREESTANDING MODELS
BATHSIDE CONTROL SYSTEMS (NON-FREESTANDING TUBS)
1: ON/OFF BLOWER
4: SPEED DECREASE
3: SPEED INCREASE
2: BLOWER CYCLES
5: CHROMATHERAPY
KEYPAD
1: ON/OFF BLOWER
4: SPEED DECREASE
3: SPEED INCREASE
2: BLOWER CYCLES
5: CHROMATHERAPY
REMOTE CONTROL
(Same Functionality as Keypad)
OR
KeyPad Functions
LED
1: ON/OFF BLOWER
1st Press: The blower starts
ON
2nd Press: The blower stops
OFF
2: BLOWER CYCLES
1st Press: Wave Cycle - Speed goes gradually from maximum to minimum.
ON
2nd Press: Pulse Cycle - Speed goes from minimum then straight back to maximum.
BLINK
3rd Press: Returns to maximum speed
OFF
3: SPEED INCREASE
1st Press: Press and hold to increase the blower speed,
release pressure at the desired speed.
When in cycles mode, increases the speed at which the cycle operates.
ON
(WHEN PRESSED)
4: SPEED DECREASE
1st Press: Press and hold to decrease the blower speed,
release pressure at the desired speed.
When in cycles mode, decreases the speed at which the cycle operates.
ON
(WHEN PRESSED)
5: Chromatherapy
1st Press: Turn on the light in white
2nd Press: Rainbow cycle – Low speed
3rd Press: Rainbow cycle – High speed
4th Press: Turquoise
5th Press: Blue
6th Press: Magenta
7th Press: Red
8th Press: Orange
9th Press: Yellow
10th Press: Green
11th Press Turn off the light
(Press and hold 2 seconds at any time to turn off the light.)
Advanced Programming
DRYING CYCLE WITH WATER DETECTORS
The drying cycle will activate 20 minutes after the bathtub is emptied even if the system was not used.
The blower touch LED blinks while waiting for the purge cycle.
INTEGRATED 20 MINUTE AUTOMATIC TIMER
Integrated 20 minute automatic timer on the complete system. Count down starts with the last system turned on.
