TYPICAL FREESTANDING BATHTUB INSTALLATION PROCEDURE
Before you start:
•
Ensure that the floor is even.
•
The wate-overflow fitting is supplied with the product, however other accessories like the slip joint and
adaptors are not included and must be purchased seaparately.
•
Because of the technical features of the product, it should be used only with the supplied waste-overflow
or specific 3rd party models that have been tested and approved by us.
•
Handgrip application for our product is not available.
•
The bathtub must be carried in the upside-down position. Do not lift or support the bathtub by the panels.
•
Place the bathtub by raising it up 3½” with 4x4 peices of lumber so you can have access from the bottom
of the bathtub.
•
For cleaning of the acrylic bathtub look at our Acrylic Bathtub Maintenance Manual.
INSTALLATION SEQUENCE
•
Picture 1-2:
the bathtub must be carried upside-down. It must never be
carried by its panel.
•
Picture 3:
the Harmony Duo bathtub is equipped with factory pre-installed overflow system .
The waste pipe/p-trap connection must be made directly to the waste/drain outlet located at the bottom of the tub.
1
2
3
www.aquaticaplumbing.com
E:
info@aquaticaplumbing.com
Harmony Duo
Freestanding Oval Bathtub
