INSTALLATION INSTRUCTIONS
Attaches to Freestanding Bath W/O
A. Cut 6½” (16.5 cm) hole into wood sub-floor
(use supplied Cutout Template).
B. Measure and cut ABS Tailpiece as necessary
to ensure a secure connection to P-Trap below.
C. Insert Freestanding Bath Installer™ assembly
into floor opening and connect to Pipe below.
D. Affix to sub-floor with 6 screws (not supplied)
A. Install flooring surface, leaving a 6½”
opening to access Drain.
B. Affix the appropriate brass Tailpiece to the Waste
& Overflow. NOTE: DO NOT CUT THE BRASS
TAILPIECE AS THIS MAY CAUSE
A LEAK.
Ensure the measurement between the base of
the Drain and P-Trap will accomodate the Tail-
piece.
A. Cut out the Installation Label with a utility knife and
remove to expose the Drain.
B. Apply lubricant (supplied) to the Tailpiece.
C. Position the Tub and brass Tailpiece in-line with the
Drain.
D. Carefully lower the tub with the installed brass Tail-
piece into the Red Collar in Drain assembly. Ensure
Tailpiece is fully engaged with Seal.
Aquatica
®
Freestanding Bath Installer
™
(Kit available separately - not included with bathtub)
1
2
3
IMPORTANT:
Do not remove Installation Label until Step 3.
DO NOT CUT THE SUPPLIED BRASS TAILPIECE
. Doing so may cause a leak.
Disassembling the drain or cutting the Tailpiece will void the warranty.
