AquiNet
Fieldbus Network System
LEAK DETECTION SOLUTIONS
Weights & Measures House, 20 Barttelot Road,
Horsham, West Sussex RH12 1DQ
+44 (0) 1403 216100
info@aquilar.co.uk
www.aquilar.co.uk
A
qui
N
et
Change the setting from obtain an IP address automatically, to use the following IP address.
Enter an IP in the same range as the Sx2WEB24 gateway, for standard settings we recommend
192.168.1.19. Click ok (the subnet mask will self populate).
Connect a ethernet patch lead from the computer into the ethernet port of the Sx2WEB24
Controller. You may have to remove the yellow ethernet lead connecting the AquiNet
touchscreen to the SxWEB24.
After a power on, the Sx2WEB24 master unit is ready to work after about 1 minute. Only when
the yellow BUS Led starts flashing the master unit is ready.
At the bottom left of the window, type in the IP address of the Sx2WEB24 you are connecting
to. The default for most configurations is 192.168.1.20. Aquilar will provide information if a
different configuration is used.
Click connect and if a successful connection is made, the grey circle will turn green and the
status light on the Sx2WEB24 will flash red.
8
