Model 2500A225C
2
Rev A
1.3.2
Primary Power
The Model 2500A225C is designed to operate using AC primary power of 200–240 Volts or 380-415
Alternating Current (VAC), 50–60 Hz, three phase, 8500 watts maximum.
CAUTION:
Dangerous voltages are present in the Model 2500A225C whenever the unit
is plugged into an AC outlet. Always disconnect the unit from the main
power line when servicing it. Please note that neither the Keylock or Power
switch will completely shut off the unit’s AC power.
Low Voltage Model 10053007
: The Model 2500A225C is designed for a primary power input of 200–240
VAC, 50/60Hz, three phase Delta (4-wire) (Wye-compatible). A 40 amp or greater, common trip circuit breaker
should be used to supply power to the 2500A225C low voltage model. Included with the low voltage model is
a 15-foot, four-conductor harmonized line cord consisting of three phase wires (Brown, Black, Grey) and a
protective GND connector (Green/Yellow).
High Voltage Model 10053008:
The Model 2500A225C is designed for a primary power input of 380–415
VAC, 50/60Hz, three phase Wye (5-wire). A 25 amp or greater, common trip circuit breaker should be used to
supply power to the 2500A225C high voltage model. Included with the high voltage model is a 15-foot, five-
conductor harmonized line cord consisting of three phase wires (Brown, Black, Grey), a neutral conductor
(Blue) and a protective GND connector (Green/Yellow).
Figure 1-1. 2500A225C AC Line Cord Installation
Summary of Contents for 0053007
